Forum FAQForum FAQSearchSearch MemberlistMemberlist Forum ignore listForum ignore list RegisterRegister ProfileProfile Log in to check your private messagesLog in to check your private messages Log inLog in
Ragged picture edge iz vektorske maske?

 
Post new topic   Reply to topic    mi3dot.org Forum Index -> Raster
View previous topic :: View next topic  
Author Message
Petar_Popara_Crni



Joined: 30 Aug 2005
Posts: 42
Location: zagreb

PostPosted: 30.07.2006 18:03    Post subject: Ragged picture edge iz vektorske maske? Add user to your forum ignore list Reply with quote

Helpajte pljiz, zaboravio sam osnovnu stvar Razz

Dakle imam layer 0 - to je fotka. Onda idem u custom shapes i "nacrtam" taj pravokutnik "potrganih" rubova preko fotke, i stvara se layer 1 (vektorski) sa maskom - tim crnim pravokutnikom.

E sad... ono sto meni treba je da taj pravokutnik "propusti" fotku odozdo kroz sebe Shocked Very Happy i da se sve van toga pobrise. Dakle, konacan rezultat treba biti fotka sa vrlo nepravilnim, poderanim, zgrebanim rubovima.

KAK DA TO DOBIJEM? Sjecam se da je nesto trebalo tak kvadrat nekako selektirati pa invert pa sejv kao alfa selekciju, pa na drugi layer di je fotka load selection konacno hit delete da se sve izvan toga zbrise ali kak je islo pojma nemam Crying or Very sad
Back to top
View user's profile Send private message Visit poster's website
pike



Joined: 09 Sep 2003
Posts: 399
Location: Zagreb

PostPosted: 30.07.2006 18:36    Post subject: Add user to your forum ignore list Reply with quote

ctrl+klik na layer s shapeom za selektiranje, pa Ctrl+shift+i = invert selection, odaberi layer s fotkom, delete i onda makni layer s custom shapeom...
Back to top
View user's profile Send private message Send e-mail AIM Address
Petar_Popara_Crni



Joined: 30 Aug 2005
Posts: 42
Location: zagreb

PostPosted: 30.07.2006 18:41    Post subject: Add user to your forum ignore list Reply with quote

bravo stari, to je to! Puno ti hvala Wink
Back to top
View user's profile Send private message Visit poster's website
gervasius



Joined: 01 Apr 2006
Posts: 91
Location: Beograd

PostPosted: 30.07.2006 18:59    Post subject: Add user to your forum ignore list Reply with quote

A moze i da postavis vektorski layer ispod layer 0, zatim na paleti layer postavi kursor izmedju layer i pritisni alt:

zatim klik i dobices ovo:

Na ovaj naci dobijes isti rezultat ali ne gubis piksele sa layer 0, za slucaj da kasnije zelis da pomeris polozaj, itd.
Back to top
View user's profile Send private message
Display posts from previous:   
Post new topic   Reply to topic    mi3dot.org Forum Index -> Raster All times are GMT + 1 Hour
Page 1 of 1

 
Jump to:  
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot vote in polls in this forum


Powered by phpBB © 2001, 2005 phpBB Group