Forum FAQForum FAQSearchSearch MemberlistMemberlist Forum ignore listForum ignore list RegisterRegister ProfileProfile Log in to check your private messagesLog in to check your private messages Log inLog in
Priprema (naljepnica)

 
This forum is locked: you cannot post, reply to, or edit topics.   This topic is locked: you cannot edit posts or make replies.    mi3dot.org Forum Index -> DTP i print dizajn
View previous topic :: View next topic  
Author Message
tokage



Joined: 04 Nov 2005
Posts: 5

PostPosted: 27.03.2010 10:17    Post subject: Priprema (naljepnica) Add user to your forum ignore list Reply with quote

Trebao bih malu pomoc oko dimenzije naljepnice za kanticu, dimenzije su sljedeće 1 5/8" rubovi tj lijeva desna strana, 5 1/4" vrh i 4 3/4" dno, znači trebala bi biti lagano zakrivljena na gornjoj i donjoj strani, kako da dobijem pripremu??? Confused


_________________
People ignore design that ignores people.— Frank Chimero
http://www.damirpolutranko.com/
Back to top
View user's profile Send private message Visit poster's website
niks



Joined: 05 May 2005
Posts: 3

PostPosted: 27.03.2010 10:44    Post subject: Add user to your forum ignore list Reply with quote

Zakrivljenje mozes napraviti pomocu Warp --> ARC effect-a u Illustratoru.
Trebat ces se samo malo poigrat dok ne dobijes odgovarajuci oblik.

pozz
Back to top
View user's profile Send private message
tokage



Joined: 04 Nov 2005
Posts: 5

PostPosted: 27.03.2010 11:01    Post subject: Add user to your forum ignore list Reply with quote

ok a da li mi mozes pojasnit ove dimenzije 1 5/8", 5 1/4" i 4 3/4" kako mogu dobiti iz ovoga visinu i širinu naljepnice?

_________________
People ignore design that ignores people.— Frank Chimero
http://www.damirpolutranko.com/
Back to top
View user's profile Send private message Visit poster's website
niks



Joined: 05 May 2005
Posts: 3

PostPosted: 28.03.2010 00:37    Post subject: Add user to your forum ignore list Reply with quote

dimenzije su u inchima --> na sljedecem linku imas kalkulator za pretvorbu u mm

http://www.startinbusiness.co.uk/si/feet_to_metres.htm
Back to top
View user's profile Send private message
Display posts from previous:   
This forum is locked: you cannot post, reply to, or edit topics.   This topic is locked: you cannot edit posts or make replies.    mi3dot.org Forum Index -> DTP i print dizajn All times are GMT + 1 Hour
Page 1 of 1

 
Jump to:  
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot vote in polls in this forum


Powered by phpBB © 2001, 2005 phpBB Group